Edmonton Electrical Services: 4 Ways To Save Energy

There are many advantages to saving energy. It helps to preserve natural resources, reduce your monthly utility bills and save wear and tear on the systems of your home in the hopes of avoiding a call to an electrician in Edmonton. Saving energy may seem complicated, but there are relatively simple things you can do to help you use less power.

1. Take Shorter Showers

You do not necessarily have to shower less often to save water and energy. Though this would probably be effective, it would be distasteful to many people. What you can do instead is to shorten your daily shower. For every minute that you shower, you use 2.5 gallons of water. If you could cut this time by four minutes per day, you would use 10 fewer gallons of water, which would amount to savings of up to 3,650 gallons per year. Furthermore, you would use less energy if you decreased the temperature of your daily shower. Not only that, but you would also decrease the risk of scald injuries from water that is too hot.

2. Turn off and Unplug Appliances When Not in Use

Vampire power consumption refers to the low level of power that certain electronics and appliances draw when turned off but still plugged in. Examples include things such as battery chargers, television sets, and countertop kitchen appliances. Look for devices that you can unplug completely when not in use.

When it comes to electronics, they are still using power even when they are idle. If you are only going to be away from your desk for a short time, the decreased power usage that comes of leaving your computer on standby or in sleep mode may be sufficient. However, if you are leaving for the night or planning to be gone for several hours, consider shutting down the computer completely to save power. If the computer and its peripherals are plugged into a power strip, you can shut them all off at once by flipping the switch, assuming that the power bar is easily accessible and does not also power something that has to remain plugged in.

3. Wash Clothes With Cold Water

In the past, laundry detergents didn’t work as well when used with cold water. Because cold water does not disinfect, washing fabrics in cold water was essentially useless except for those for which it was specified. Coldwater just got clothes wet; it did not get them clean. Today, however, things are different. Detergents are formulated to work just as well in cold water as they do in hot or warm. Clothes washers are more efficient as well. If you have the need to disinfect as well as clean, you still need hot or warm water. However, if you do the majority of your washing in cold water, you can save significantly on your annual utility bills.

4. Air Dry Dishes Instead of Using the Drying Cycle

The drying cycle on your dishwasher is intended to cause water left on dishes to evaporate by exposing it to heat. This is not a very efficient way of drying dishes. It uses more energy and causes your kitchen to heat up. Your dishwasher should have the option to set it to air dry. You can choose this option and dry your dishes after the rinse cycle by cracking open the door, assuming that the springs are still in good enough condition to hold this position. This is a two-fold energy saving because you do not need to cool down your kitchen afterward.

Find Your Electrician in Edmonton From Handyman Connection

Contact Handyman Connection for electrical repair services in Edmonton. Our technicians have the expert training and years of experience necessary to perform the repairs safely and effectively.